[Aide] shutting off mmpping
Rami Lehti
rammer at ipi.fi
Fri Apr 4 10:48:46 EEST 2014
The configure command should be.
./configure --without-mmap
Kind regards,
Rami Lehti
On 03.04.2014 23:38, Yunker, James M CIV NUWC NWPT wrote:
> I must ask this question again. I am trying to use the rpm version of AIDE. I believe that version is 0.14.
>
> However, when I use it I get error that reads:
>
>
> Caught SIGBUS/SEGV while mmapping. File was truncated while aide was running?
> Caught SIGBUS/SEGV. Exiting
>
>
> I believe that the only way to remove this error is to configure aide without mmapping. You said that in a previous post.
>
> The only way that I know of how to do that is by the command:
>
> ./configure without-mmapping
>
> Which precedes the make, and make install commands.
>
> When someone works with the source code in aide-01.5.tar.gz that can be done, and only when someone works with the source code.
>
> The rpm version of aide is already configured with mmapping and there is no direct way to shut it off.
>
> Thus we are forced to avoid the rpm version and use the source code version, tar.0.15.tar.gz when installing aide.
>
> This seems to be the only way, if there is another then please tell me.
>
> Thanks in advance.
>
>
> Respectfully,
>
>
> James M. Yunker
>
> PS. This error, which reads :
>
> Caught SIGBUS/SEGV while mmapping. File was truncated while aide was running?
> Caught SIGBUS/SEGV. Exiting
>
> Is unique to this version of aide (an rpm version) and a successor version of aide in a rpm format will correct this.
>
> That is what I can learn from looking at emails and looking that error up on the internet.
>
>
>
>
>
>
> _______________________________________________
> Aide mailing list
> Aide at cs.tut.fi
> https://mailman.cs.tut.fi/mailman/listinfo/aide
>
More information about the Aide
mailing list